Christie Mirage M Series User Manual page 80

secondary image, when using Dual input 3D. Free Run sets the output to close to 60Hz for all
sources. This control must be set to locked if a 3D-Stereo signal is used.
• Set Frame Delay—Delays the output signal timing relative to the input signal timing by a
fraction of a frame, and up to several frames. The minimum latency can vary based on the
amount of scaling applied to the image. When using keystone or warping, an additional latency
is required, depending on the amount of warp. The control is only available when the input
signal is frame locked. In free run mode, or in cases where the signal cannot be frame locked,
the minimum latency defined by the scaling and keystone/warp is applied to the signal.
• Actual Frame Delay—Displays the actual frame delay reading.
• Full Screen Eye-Motion Filter—Check this control to apply the Eye-Motion Filter to the entire
screen, rather than applying just to the edge blending regions. Helps with posterization effects,
sometimes seen in color ramps when viewing stereoscopic images.
• Eye-Motion Filter—Adjust this filter to reduce saccadic eye-motion artifacts, sometimes
noticeable in edge blending regions. Too much filtering may result in loss of detail. For best
results, adjust this setting while positioned at the nominal screen-viewing distance.
• Edit Secondary Channel Settings—When using Dual Input 3D, this allows you the option to
independently control primary and secondary channel settings, or to use the same setting for
both links. By default, this control is unchecked, meaning any settings applied to the primary
input also applies to the secondary input. In this case, the secondary channel settings cannot
be set. When checked, the secondary channel settings become editable.
• Main Input—Select an input from the drop-down list.
• Secondary Input—Select an input to be used as secondary input in a Dual Input 3D setup.
• Display 3D Message Boxes—Enable/Disable message boxes that are triggered by 3D setup.
No message box is shown in Off and Valid state.
Example of 3D multiple display setup
1. Setup the warp and blends.
2. If necessary, shift or scale your image to fit the display.
3. Set all projectors to the largest minimum Frame Delay value that the worst case projector in
the array can achieve.
4. To enable 3D mode on all projectors, select Main Menu > Image Settings > Advanced
Image Settings > 3D Settings
5. Set all projectors 3D Sync Output to Next Projector with the exception of the last projector;
select To Emitter.
6. Connect the PC emitter sync to either Input A (or B) on the 3D dongle.
7. Connect the output from the 3D dongle in the first projector to Input A (or B) on the next
projector in the array.
8. Repeat the same procedure to all projectors except the last projector in the array. Route the
Sync output from the 3D dongle to the emitter. For the last projector, route the sync input.
9. If your emitter has a reverse setting ensure it is set to the Off position.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Operating the projector
80