Troubleshooting; Power; Projector Does Not Power On - Christie Mirage M Series User Manual

Troubleshooting

If the projector is not operating properly, note the symptoms and use this section as a guide to
resolve the problem. If the problem cannot be resolved. contact your dealer for assistance.
Warning! Failure to comply with the following could result in death or serious injury.
• A Christie qualified technician is required when opening an enclosure

Power

Learn more about resolving common power-related issues.

Projector does not power on

1. Ensure projector is plugged in. Check power switch above power cord is in the on position.
2. Check that the Status LEDs are on.
While the projector is busy initializing, the LEDs should be cycling. When finished initializing,
the Power and Shutter LEDs (the two on the right) should be on.
3. Check the LCD display.
While the projector is busy initializing, the display should show "Please wait". When finished
initializing, the display should show "Standby mode".
4. Check the LCD display for any warnings or errors.
A condition occurs on the first power on after a software upgrade, and is indicated by all the
following:
• The Status LEDs are cycling green
• The LCD displays the warning "Image Processor Upgrading"
• The LED on the Image Processor card flashes green
• The Web page shows a warning that the Image processor card is upgrading.
When this occurs, the projector should not be AC power cycled and the Image Processor card
should not be removed. This operation may take as long as five minutes to complete.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Troubleshooting
118