Christie Mirage M Series User Manual page 81

10. Set all projectors to 3D Sync Input A (or B) depending on your selection in Step 6 and 7.
11. Apply the 3D test pattern to all projectors.
12. Put on your 3D glasses.
13. When 3D is setup correctly, a small set of Ls are visible by closing your right eye and a small set
of Rs are visible when closing your left eye.
14. If necessary, adjust the dark interval settings until the test pattern sees the least amount of
ghosting for each projector.
15. Adjust the 3D Sync Delay on the last projector in your array to match the optimal sampling
point for the glasses being used.
The default auto setup value is typically good for all glasses.
16. Turn off the 3D test pattern on each projector.
Your 3D content should look optimal.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Operating the projector
81