Replacing The Option Cards; Removing The User Interface Module - Christie Crimson Series Service Manual

Replacing the option cards

The projector comes standard with a high bandwidth multiple input card (HBMIC).
1. On the option card you want to remove, loosen the two captive screws on the faceplate and
pull out the option card.
2. Replace the option card, if required.
3. To re-install, repeat these steps in reverse order.

Removing the user interface module

The user interface module mounts to the electronics side of the projector.
Using the side panel display, the user can view and control input and output activities on the projector.
The near field communication (NFC) reader on the user interface module enables Android devices to
communicate with the projector.
1. Remove the electronics-side cover (on page 43).
2. Loosen the four captive screws securing the user interface module and remove it.
Crimson Service Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102733-02 Rev. 1 (01-2020)
Copyright 2020 Christie Digital Systems USA, Inc. All rights reserved.
©
Electronics
67