Installing The At-X550-18Xtq Or At-X550-18Xsq Switch In An Equipment Rack With The At-Rkmt-J14 Brackets; Required Items; Switch Orientations In The Equipment Rack; Figure 36: Bracket Holes - Allied Telesis AT-x550-18XTQ Installation Manual

Installing the AT-x550-18XTQ or AT-x550-18XSQ Switch in an
Equipment Rack with the AT-RKMT-J14 Brackets

Required Items

Switch
Orientations in
the Equipment
Rack
This section contains the procedure for installing the AT-x550-18XTQ or
AT-x550-18XSQ Switch in a standard 19-inch equipment rack, with the
AT-RKMT-J14 Brackets included with the switch.
The following items are required to install the switch in an equipment rack
with the AT-RKMT-J14 Brackets:
 Two AT-RKMT-J14 equipment rack brackets (included with the
switch)

Eight M4x6mm bracket screws (included with the switch)

Four M3x6mm screws (included with the switch)

Two bracket handles (included with the switch)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)
The switch has two sets of four screw holes on the left and right sides, for
attaching the AT-RKMT-J14 Brackets. Refer to Figure 36.
The brackets also have two sets of four holes. Refer to Figure 37 on page
96.
x550 Series Installation Guide for Virtual Chassis Stacking
Bracket Holes
Figure 36. Bracket Holes
95