Installing A Plywood Base - Allied Telesis AT-x550-18XTQ Installation Manual

Installing a Plywood Base

A plywood base is recommended when installing the switch on a wall that
has wooden studs. Refer to "Plywood Base for a Wall with Wooden Studs"
on page 115. Consult a qualified building contractor for installation
instructions for the plywood base. The installation guidelines are listed
here:

Use a stud finder to identify the middle of studs and hot electrical
wiring in the wall.
 Attach the base to two wall studs with a minimum of four screws.
 The selected wall location for the base should provide sufficient
space from other devices or walls so that you can access the front
and back panels, and for adequate air flow for ventilation.
x550 Series Installation Guide for Virtual Chassis Stacking
117