Powering On A Switch; Figure 69: Installing The Power Cord Retaining Clip - Allied Telesis AT-x550-18XTQ Installation Manual

Powering On a Switch

Before powering on a switch, review the information in "Power
Specifications" on page 186 for the power specifications of the switches.
Warning
Power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.  E3
Note
Pluggable Equipment. The socket outlet shall be installed near the
equipment and shall be easily accessible.  E5
To power on a switch, perform the following procedure:
1. Install the power cord retaining clip on the AC power connector on the
rear panel of the switch. Refer to Figure 69.
Figure 69. Installing the Power Cord Retaining Clip
2. Connect the AC power cord to the AC power connector on the rear
panel of the switch. Refer to Figure 70.
x550 Series Installation Guide for Virtual Chassis Stacking
137