Installing At-Qsfpsr4 Or At-Qsfplr4 Transceivers - Allied Telesis AT-x550-18XTQ Installation Manual

Chapter 8: Cabling the Networking Ports

Installing AT-QSFPSR4 or AT-QSFPLR4 Transceivers

176
This section contains the procedure for installing AT-QSFPSR4 or AT-
QSFPLR4 transceivers in the QSFP+ ports 17 and 21.
Please review "Guidelines to Handling SFP, SFP+, and QSFP+
Transceivers" on page 169 before performing this procedure.
To install AT-QSFPSR4 or AT-QSFPLR4 transceivers, perform the
following procedure:
1. Remove the dust cover from QSFP+ slot 17 or 21. Refer to Figure 84
on page 177.
2. Slide a QSFP+ transceiver into the slot until it clicks into place.
3. Attach fiber optic cable to the transceiver.
4. Connect the other end of the cable to a compatible QSFP+ port in
another network device.
5. Repeat this procedure to install a second QSFP+ transceiver.
Note
To remove the connector and cable from the slot, gently push on the
connector, pull on the release tab, and slide the connector from the
slot.