Installing The Switch In An Equipment Rack With The At-Rkmt-J14 Brackets; Required Items For The At-Rkmt-J14 Brackets; Switch Orientations In The Equipment Rack; Figure 18: Bracket Holes - Allied Telesis AT-x550-18XTQ Installation Manual

Installing the Switch in an Equipment Rack with the AT-RKMT-J14
Brackets
Required Items
for the AT-
RKMT-J14
Brackets
Switch
Orientations in
the Equipment
Rack
This section contains the procedure for installing the switch in a standard
19-inch equipment rack, with the two AT-RKMT-J14 Brackets included
with the switch.
The following items are required to install the switch in an equipment rack
with the AT-RKMT-J14 Brackets:
 Two AT-RKMT-J14 equipment rack brackets (included with the
switch)

Eight M4x6mm bracket screws (included with the switch)

Four M3x6mm screws (included with the switch)

Two bracket handles (included with the switch)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)
The switch has two sets of four screw holes on the left and right sides, for
attaching the AT-RKMT-J14 Brackets. Refer to Figure 18.
The brackets also have two sets of four holes. Refer to Figure 19 on page
60.
x550 Series Installation Guide for Virtual Chassis Stacking
Bracket Holes
Figure 18. Bracket Holes
59