Leds; Installation Options; Management Software And Interfaces; Management Methods - Allied Telesis AT-x550-18XTQ Installation Manual

QSFP+ transceivers must be purchased separately. For a list of supported
transceivers, refer to the product data sheet on the Allied Telesis web site.

LEDs

Here are the port LEDs:
Installation
Here are the installation options:
Options
Management
Here are the management software and interfaces:
Software and
Interfaces
Management
Here are the methods for managing the switches:
Methods
 AT-QSFP1CU and AT-QSFP3CU direct connect cables in lengths
of 1 and 3 meters, respectively
 AT-QSFP-4SFP10G-3CU and AT-QSFP-4SFP10G-5CU breakout
cables in lengths of 3 and 5 meters, respectively
Note
Ports 17 and 21 are initially configured as trunk ports for the
VCStack feature. To use them as regular networking ports, either
disable the VCStack feature or designate other ports as stacking
ports. Refer to "Stack Trunk" on page 54.
 Link/activity LEDs for twisted pair ports 1 to 16 on the AT-x550-
18XTQ Switch and ports 1 to 8 on the AT-x550-18XSPQm Switch
 Link/activity LEDs for SFP and SFP+ transceiver ports 1 to 16 on
the AT-x550-18XSQ Switch and ports 9 to 16 on the AT-x550-
18XSPQm Switch

Link/activity LEDs for the QSFP+ transceiver ports 17 and 21
 PoE+ LEDs on the AT-x550-18XSPQm Switch
 Stack ID number LED
 eco-friendly button turns off the LEDs to conserve electricity
 Desk or tabletop
 19-inch equipment rack
 Wooden or concrete wall

AlliedWare Plus Management Software

Command line interface

Web browser interface
 Local management through the Console port
 Remote Telnet or Secure Shell management
 Remote HTTP or HTTPS web browser management
 SNMPv1, v2c, and v3
x550 Series Installation Guide for Virtual Chassis Stacking
23