Figure 40: Attaching The Handles To The At-Rkmt-J14 Brackets; Figure 41: Attaching The At-Rkmt-J14 Brackets To The Switch - Allied Telesis AT-x550-18XTQ Installation Manual

Chapter 4: Installing the Switch on a Table or in an Equipment Rack
98
Figure 40. Attaching the Handles to the AT-RKMT-J14 Brackets
2. Place the switch on a level, secure surface.
3. Attach the two brackets to the sides of the switch in the selected
position, using the eight M4x6mm screws included with the unit. (Refer
to Figure 38 on page 96 and Figure 39 on page 97.) The illustration in
Figure 41 shows the installation of the brackets such that the front
panel of the switch is even with the front of the equipment rack.
Figure 41. Attaching the AT-RKMT-J14 Brackets to the Switch