Installing The Switch In An Equipment Rack With The At-Rkmt-J15 Bracket; Required Items; Installing The Switch; Figure 23: Installing The At-Rkmt-J15 Bracket In The Equipment Rack - Allied Telesis XS900MX Series Installation Manual

Chapter 3: Installing the Switch on a Table or in an Equipment Rack
Installing the Switch in an Equipment Rack with the AT-RKMT-J15
Bracket

Required Items

Installing the
Switch
50
This section contains the procedure for installing XS900MX Switches in a
standard 19-inch equipment rack, with the optional AT-RKMT-J15
Bracket.
The following items are required to install the switch in an equipment rack
with the AT-RKMT-J15 Bracket:
 One AT-RKMT-J15 equipment rack bracket (sold separately)
 Four M4x6mm bracket screws (included with the switch)
 Cross-head screwdriver (not provided)
 Flat-head screwdriver (not provided)
 Four standard equipment rack screws (not provided)
To install the switch in a 19-inch equipment rack with the AT-RKMT-J15
Bracket, perform the following procedure:
1. Have another person hold the AT-RKMT-J15 Bracket at the desired
location in the equipment rack while you secure it using four standard
equipment rack screws (not provided). Refer to Figure 23.
Figure 23. Installing the AT-RKMT-J15 Bracket in the Equipment Rack