Installing The Switch; Figure 39: Switch Orientations With The Rear Panel Facing The Front Of The Equipment Rack - Allied Telesis AT-x550-18XTQ Installation Manual

You can also orient the switch with the rear panel facing the front of the
equipment rack. Refer to Figure 39.
Figure 39. Switch Orientations with the Rear Panel Facing the Front of the
Installing the
If you have not chosen an orientation for the switch in the equipment rack,
review "Switch Orientations in the Equipment Rack" on page 95.
Switch
Please review the installation guidelines in "Choosing a Site for the Switch"
on page 84 before installing the switch in an equipment rack.
To install the switch in a 19-inch equipment rack with the AT-RKMT-J14
Brackets, perform the following procedure:
1. Attach the two handles to the AT-RKMT-J14 Brackets using the four
Caution
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack.  E28
M3x6mm screws included with the switch. Refer to Figure 40 on page
98.
x550 Series Installation Guide for Virtual Chassis Stacking
Equipment Rack
97