Figure 67: Returning To The Privileged Exec Mode; Figure 68: Saving The Priority Values With The Write Command - Allied Telesis AT-x550-18XTQ Installation Manual

Chapter 6: Building the Trunk with Default Stacking Ports 17 and 21
136
4. After setting the priority values, enter the EXIT command to return to
the Privileged Exec mode, as shown in Figure 67 on page 136.
awplus(config)# exit
awplus#
Figure 67. Returning to the Privileged Exec Mode
5. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 68.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 68. Saving the Priority Values with the WRITE Command
6. To end the management session, enter the EXIT command.
7. Go to Chapter 8, "Cabling the Networking Ports" on page 167, to
continue with the installation.