Installing The X530L-10Ghxm Switch In An Equipment Rack With The Rkmt-J15 Bracket; Required Items; Installing The Switch - Allied Telesis x530L Series Installation Manual

Installing the x530L-10GHXm Switch in an Equipment Rack with the
RKMT-J15 Bracket

Required Items

Installing the
Switch
This section contains the procedure for installing the x530L-10GHXm
switch in a standard 19-inch equipment rack, with the optional RKMT-J15
Bracket.
The following items are required to install the x530L-10GHXm switch in an
equipment rack with the RKMT-J15 Bracket:
One RKMT-J15 equipment rack-mount bracket (sold separately)

Four M4x6mm bracket screws (included with the RKMT-J15)

Cross-head screwdriver (not provided)

Flat-head screwdriver (not provided)

Four standard equipment rack screws (not provided)

Note
If the rubber feet have been attached to the device, remove them.
To install the x530L-10GHXm switch in a 19-inch equipment rack with the
RKMT-J15 Bracket, perform the following procedure:
1. Have another person hold the RKMT-J15 Bracket at the desired
location in the equipment rack while you secure it using four standard
equipment rack screws (not provided). Refer to Figure 56 on page 116.
x530L Series Installation Guide for Virtual Chassis Stacking
115