Table 22: Configuring The Master Switch For Optional Stacking Ports - Part Ii - Allied Telesis AT-x550-18XTQ Installation Manual

Table 22. Configuring the Master Switch for Optional Stacking Ports - Part II (Continued)
Step
4 Remove the stacking function from the ports to convert them into regular Ethernet
ports, with the NO STACKPORT command:
awplus(config-if)# no stackport
% Save the config and restart the system for this change to take
effect.
Steps 5 and 6 add the stacking function to the selected optional stacking ports on the
provisioned member switches.
5 Enter the Interface modes of the optional stacking ports to be used as the stack trunk
on the provisioned member switches. If you filled out the worksheet on Table 19 on
page 76, refer there for the stacking ports. This example assumes that three member
switches are using ports 15 and 16 as the stack trunk.
awplus(config)# interface port2.0.15-2.0.16,port3.0.15-
3.0.16,port4.0.15-4.0.16
6 Designate the ports as stacking ports with the STACKPORT command.
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
Steps 7 to 13 save your changes on the master switch and reboot it.
7 Return to the Global Configuration mode.
awplus(config-if)# exit
8 Return to the Privileged Exec mode.
awplus(config)# exit
9 Enter the WRITE command to save your changes.
awplus# write
Building configuration ...
[OK]
10 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
11 Type "Y" for yes.
12 Wait two minutes for the switch to initialize the management software.
AT-x550 Series Installation Guide for Virtual Chassis Stacking
Description and Command
153