Installing The Switch In An Equipment Rack With At-Rkmt-J14 Brackets; Required Items; Switch Orientations In The Equipment Rack; Figure 23: Bracket Holes For At-Rkmt-J14 Brackets - Allied Telesis XS900MX Series Installation Manual

Installing the Switch in an Equipment Rack with AT-RKMT-J14
Brackets

Required Items

Switch
Orientations in
the Equipment
Rack
This section contains the procedure for installing XS900MX Switches in a
standard 19-inch equipment rack, with the AT-RKMT-J14 Brackets
included with the units.
The following items are required to install the switch in an equipment rack
with the AT-RKMT-J14 Brackets:
 Two AT-RKMT-J14 equipment rack brackets (included with the
switch)

Eight M4x6mm bracket screws (included with the switch)

Four M3x6mm screws (included with the switch)

Two bracket handles (included with the switch)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)
The switch has two sets of four screw holes on the left and right sides, for
attaching the AT-RKMT-J14 Brackets. Refer to Figure 23.
Figure 23. Bracket Holes for AT-RKMT-J14 Brackets
XS900MX Series Installation Guide for VCStack
Bracket Holes
Bracket Holes
59