What To Do Next; Figure 76: Powering Off The Switch - Allied Telesis AT-x550-18XTQ Installation Manual

Step
4 Enter the SHOW RUNNING-CONFIG command to display the running configuration
of the master switch.
awplus# show running-config
Use the display to confirm that you designated the correct trunk ports for the master
and member switches. The ports should be designated with INTERFACE PORT and
STACKPORT commands. In the following example, ports 15 and 16 on the master
and member switches will be the stack trunk:
interface port1.0.15-1.0.16
stackport
.
interface port2.0.15-2.0.16
stackport
.
interface port3.0.15-3.0.16
stackport
.
interface port4.0.15-4.0.16
stackport
Go to "What to Do Next" on page 155.
5

What to Do Next

Table 23. Verifying the Master Switch (Continued)
Description and Command
After configuring the master switch, do the following:
1. Power off the switch by disconnecting its AC power cords from the AC
power sources. Refer to Figure 76 on page 155.
Figure 76. Powering Off the Switch
2. Configure the member switches. Refer to "Configuring Member
Switches" on page 157.
AT-x550 Series Installation Guide for Virtual Chassis Stacking
155