Table of Contents
Advertisement
Chapter 1: Overview
LEDs
Table 2. Link and Activity Status LEDs for 1Gbps SFP, 10Gbps SFP+, SP10TM
Solid Green
Flashing Green
Solid Amber
Flashing Amber
Off
20
The LEDs are located between the ports. Each port has one LED. Refer to
Figure 4.
Top Transceiver Port LED
Figure 4. Link and Activity LEDs for Ports for 1Gbps SFP, 10Gbps SFP+,
The LEDs display link and activity status. The possible LED states are
described in Table 2.
State
The transceiver has established a 10Gbps link to a network
device.
The transceiver is transmitting or receiving data in 10Gbps.
The transceiver has established a 1Gbps link to a network
device.
The transceiver is transmitting or receiving data in 1Gbps.
Possible causes of this state are listed here:
- The transceiver slot is empty.
- The transceiver has not established a link to a network
device.
- The LEDs are turned off. To turn on the LEDs, use the
eco-friendly button in the management panel or the NO
ECOFRIENDLY LED command in the command line
interface.
Note
The x950-52XSQ and x950-52XTQm switches do not
have the eco-friendly button.
Bottom Transceiver Port LED
or SP10TM Transceivers
Transceivers
Description
Advertisement
Table of Contents
