Touch Screen Calibration Wizard - Raven Viper Pro Installation & Operation Manual

Chapter 3

Touch Screen Calibration Wizard

When the operator touches an area of the screen, the Viper Pro displays an arrow in the area where the
selection has been made. If this arrow does not appear in the correct location, the touch screen may require
recalibration.
There are two ways to access the Touch Screen Calibration Wizard:
•
Press the power button while the start up prompt is displayed.
•
Select the Calibrate Screen option at the bottom of the Program Selection Menu screen.
To complete the Touch Screen Calibration Wizard:
Touch and hold in the center of the first of four calibration points.
1.
When prompted, release the point. The next calibration point will be displayed.
2.
Touch and hold the center of each remaining calibration point as they are displayed.
3.
Once all points have been calibrated, touch in various areas of the screen to verify that the arrow appears in
4.
the correct location.
Note:
This screen will only be displayed for 1 minute. A count down of time remaining is displayed on the
Cancel button. If the calibration is not accepted before 1 minute lapses, the calibration will be
discarded and Viper Pro will continue to start up with the previous touch screen calibration.
Touch the Accept button to apply the recalibration and continue the Viper Pro start up sequence. Touching
5.
the Cancel button discards the recalibration and the Viper Pro will start up with the previous touch screen
calibration.
26 Viper Pro Installation & Operation Manual