Application Rates Area - Raven Viper Pro Installation & Operation Manual

Application Rates Area

The target rate and control mode for each product in a product chain may be adjusted using the same tools
available for nodes or channels controlled individually. Review the Application Rates Area section on page 87
for details on the information displayed in this area and on setting the target rate for product nodes or control
channels.
Note:
Touching the "Chain" button in the Application Control prompt will display the settings screen for
the first node in the chain. Each node must be set up separately for the chained product
application.
To adjust chaining settings for configured product chains during a job, touch within the Application Rates area
on the main screen. The Application Control screen displays.
The text under the 'Chain' button lists the chain sequence order in which nodes will advance if the chain is set
to automatically advance.
In Job Chain Settings
Touch the Active button on the Application Control prompt to view the Select Active Chained Product screen.
The nodes or channels assigned to the product chain during the job setup are displayed on this screen. The
nodes are listed in the order that they will be used if 'Auto Advance' is left on. The settings are global for the
product chain and not node specific. To manually switch the active tank or bin in the chain, touch the desired
node or control channel.
Note:
If Advance on Bin Level Sensor Alarm is selected, all products in the chain must have a bin level
sensor installed.
Manual No. 016-0171-122 Rev. I
Product Chaining
125