Table of Contents
Advertisement
Booms
Sections assigned to the selected channel can be changed by touching the Booms button at the bottom of the
screen.
Confirm the boom or section selections are correctly set up for the equipment being used.
Note:
The boom or section selections are also accessible before setting up a job through the Product
Control area on the Viper Pro Main screen. Refer to the Section Assignments section on page 130
for more information.
Default Rate
Touch the Default Rate button to enter a standard rate of application for the channel when no prescription
information is available. The default rate only affects areas where prescription rate information has not been
entered.
Note:
Zero rate zones will not be affected by the default rate setting.
Conversion Factor
Rate Conversions may be used to calibrate a prescription map recommendation for the application or a
different product.
For Example:
Enter a value of '2' to double the prescription rates on the selected prescription map or a value of "0.8" to
apply 80% of the prescribed rate.
The Rate Conversions may also be used to convert a prescription map from liters or ounces to gallons, or
gallons to ounces or liters. Press the Common Factors button to view some common rate conversion values.
Note:
The Rate Conversion value must be greater than zero. In most applications, the conversion factor
will be left at the default setting of 1.0.
Manual No. 016-0171-122 Rev. I
Using the Viper Pro System
75
Advertisement
Table of Contents
Troubleshooting
