Alarms - Raven Viper Pro Installation & Operation Manual

Alarms

If the Viper Pro is configured as the CANbus controller, the field computer will display a specific warning
prompt for any configured alarm conditions encountered. Any new warning conditions encountered by the field
computer will be displayed automatically when the condition is detected and will contain information to assist
the operator with addressing the alarm condition.
If Touch the Display Data icon to access an overview of the tally register or current active alarm information for
each product node or control channel directly from the main screen.
In addition to the warning prompt, the Product Control area on the main screen will display a yellow 'warning'
indicator instead of the green 'thumbs up' symbol and a Current Alarms button will be displayed at the bottom
of the CAN Controller Status screen if an alarm condition is active.
Note:
Off rate and low limit alarms will automatically clear once the condition has corrected itself. All
other alarms will need to be cleared by touching the OK button on the warning prompt.
Manual No. 016-0171-122 Rev. I
Using the Viper Pro System
101