Starting A New Agx Job - Raven Viper Pro Installation & Operation Manual

Starting a New AgX Job

Note:
Make sure all nodes connected to the CANbus are recognized and programmed correctly. Refer to
Chapter 4, Initial Set Up and Navigation if nodes do not appear to be recognized by the field
computer.
To begin a job using AgX recommendations and pre-populated job and product information:
Select Menu, then Start Job.
1.
Select New AgX Job.
2.
Note:
If AgX recommendations have not been transferred to the field computer, or if the AgX activation
code has not been entered and validated, the Viper Pro will display a prompt. Contact a local
Raven dealer to acquire an AgX activation code or refer to AgX File Maintenance section on
page 200 for assistance transferring recommendations from a USB flash drive to the Viper Pro.
Manual No. 016-0171-122 Rev. I
Using the Viper Pro System
69