Raven Viper Pro Installation & Operation Manual page 158

Chapter 8
The following memory indicators may be shown when the internal memory is running low.
The Viper Pro automatically checks remaining internal storage space and will display an alert if the internal
storage space is almost full. This warning can be cleared by touching the OK button.
Runtimes. The application runtime is the overall time that the Viper Pro application management system has
been in operation on the field computer. The version runtime displays the run time of the currently installed
software version.
CAN Firmware Version. This value displays the current version of firmware used for CAN communication.
Note:
Version 16 or higher CAN firmware is required to allow the Viper Pro to update nodes over the
CANbus.
BIOS Version. The BIOS version currently used by the Viper Pro field computer.
Windows™ OS Version. This value is the image version of the Windows operating system installed on the
field computer.
Adjust Brightness
Touch the Adjust Brightness button at the bottom of the About Viper prompt to display the Adjust Brightness
settings.
Mode Selection Button -
Day Mode Enabled
The Adjust Brightness settings prompt displays the following:
Day/Night Mode Selection Button. The mode selection button also displays the current mode enabled.
Touch this button until the desired mode is displayed.
Increase/Decrease Arrows. Touch the arrows pointing up and down to either increase or decrease the
display brightness. Touch and hold for five seconds to change the brightness value in increments of 5.
Brightness Value. The current display brightness setting is displayed in the center of the window. In Day
mode, this value may be set between 50 and 100. In Night mode, the brightness value may be set between 0
and 100.
148
Memory Low
Less than 30 MB of space remaining
Memory Critical
Less than 25 MB of space remaining
Mode Selection Button -
Night Mode Enabled
Viper Pro Installation & Operation Manual