Job Issues - Raven Viper Pro Installation & Operation Manual

Issue
• The streetmaps files are
not located in the
streetmaps folder
• Streetmaps are located
in a sub-folder in the
Streetmaps will not
Streetmaps folder
load
• Streetmaps are not in the
correct format
• Too many streetmaps
files in the Streetmaps
folder

Job Issues

Issue
• Boom switches are
turned off
Boom numbers are
• AccuBoom enabled but
gray
machine not moving
• CAN is disconnected
• The boom is not set up
properly
Boom number does
• Nodes not completely
not turn green when
programmed
turned on
• The boom is
disconnected
Serial Console
AccuBoom
• Boom switches on
controlled boom console are in the 'On'
position
sections will not turn
off
CAN System
• Boom switches are in the
AccuBoom will not
'Off' position
turn on
• Not a CAN system
Product function
• Product application is
keys do not work
turned off
• No GPS
Dates and time are
• No GPS RMC or ZDA
incorrect
• Incorrect time zone
selected
Manual No. 016-0171-122 Rev. I
Possible Cause
• Move the streetmaps files to the Streetmaps folder on the disk.
• Move the streetmaps to the Streetmaps root folder.
• Save the streetmap files in the shapefile format.
• Limit the number of county streetmap files in the Streetmap
folder.
Possible Cause
• Turn boom and master switch on.
• Move the machine out of the applied zone.
• See the CAN Troubleshooting section on page 212.
• Check the boom setup from the Setup menu.
• Check node calibration and ensure all calibration is completed.
• Check the connection and wiring to the boom.
• Boom switches for parallel AccuBoom systems must be in the
'Off' position.
• Boom switches for CAN AccuBoom must be in the 'On' position.
• Product function keys work only in a CAN system.
• Switch product application to either auto or manual mode.
• Make sure that the GPS receiver is operating properly and that
there is a green 'thumbs-up' icon displayed in the GPS section of
the main screen.
• Check the GPS receiver to make sure the RMC or ZDA string is
selected.
• Verify the time zone selected in the Menu/Setup/Local/Time
Zone section.
Troubleshooting the Viper Pro System
Solution
Solution
207