Navigating The Viper Pro Interface; Main And Job Screen Displays - Raven Viper Pro Installation & Operation Manual

Navigating the Viper Pro Interface

The following sections provide an overview to navigation of the Viper Pro user interface and may be used to
familiarize operators to various information displays on the Viper Pro touchscreen and for help navigating
through settings screens and menus. Detailed information about the individual settings may be found in
Chapter 8, Advanced Settings and Features.

Main and Job Screen Displays

The following information can be found on the Viper Pro screen:
1
4
6
9
11
13
Active Profile or
1.
Product Selection
Tabs
5.
Product Rates
9.
Area
Product Control
13.
Status Display
Active Profile and Product Selection
The active profile is displayed above the map area on the Main tab. Before starting a job, be sure that the
correct profile is selected.
During an active job, the map area displays coverage or as-applied information based upon the product node
or control channel selected in this area.
Note:
The Viper Pro may also display an on-screen light bar at the top of the screen during an active job.
Refer to the Light Bar Guidance section on page 168 to enable the
on-screen light bar feature.
Manual No. 016-0171-122 Rev. I
2
3
or
5
7
8
10
12
14
15
Vehicle Heading
2. 3.
and Speed
Map Tools
6. 7.
Boom Status
10. 11.
Display
AutoBoom System
14. 15.
Status
Initial Set Up and Navigation
1
4
6
9
Dual Pressure Map Area
4.
Displays
Display Data Wireless
8.
Communication
Status
GPS Status SmarTrax Status
12.
Display Indicator (if
present)
Menu
10
2
3
5
7
8
13 11
12
14
15
53