Generation 1 Cable Connections - Raven Viper Pro Installation & Operation Manual

Generation 1 Cable Connections

Ensure that the field computer has been properly mounted and all component cabling is connected properly
before connecting the Viper Pro to power.
Interface Cable Connection Diagram
FIGURE 2.
+12V DC
GND
Route the conduit with red and white leads to a clean, controlled power source such as a clean power bus
1.
bar or junction box.
Connect the red lead wire to a clean +12V DC power source.
2.
Manual No. 016-0171-122 Rev. I
Auxiliary
Power Output
3 Amps Max.
Ext. Switch
+12V Switched
CAUTION
Even when the field computer is powered off,
the computer will draw a small current from the
battery. Connect the red wire to a controlled
power source or, if the machine will not be in
use for an extended period of time, remove
power from the field computer.
To prevent accidental data loss, the red wire
should be connected to a clean power source.
Installation, Start Up and Registration
To Field Computer
Main Interface Port
CANbus
Console
DGPS
17