Table of Contents
Advertisement
Chapter 10
AutoBoom™ Status Display
The current status of AutoBoom can be determined by viewing the AutoBoom area on the Viper main screen.
Note:
If a center ultrasonic sensor is installed, Ctr Ht is displayed in the AutoBoom area in place of the
set height.
Refer to the CAN AutoBoom Calibration and Operation Manual for detailed instructions on calibrating and
operating either the UltraGlide or PowerGlide Plus AutoBoom systems with the Viper Pro field computer.
186
AutoBoom is detected but is not calibrated. The AutoBoom system
must be calibrated before operation
AutoBoom is detected and calibrated, but currently turned off. Turn
on AutoBoom to use.
AutoBoom was detected but communication has been lost.
Troubleshoot AutoBoom
AutoBoom is detected and on, but is not enabled. Press the two A's
to enable AutoBoom.
AutoBoom is detected and in operation. No errors are detected in
the operation.
AutoBoom is detected and on but is not enabled. Alarm conditions
have occurred on both booms. Troubleshoot.
AutoBoom is detected and on and is enabled. Alarm conditions
have occurred on both booms. Troubleshoot.
Viper Pro Installation & Operation Manual
Advertisement
Table of Contents
Troubleshooting
