Raven Viper Pro Installation & Operation Manual page 59

Press Next when all of the section width information has been entered. The boom summary screen
6.
displays.
Note:
If the section widths do not match the overall guidance width, the Viper Pro will display a 'Boom
Setup Warning' to alert the operator to a potential issue. Review the section configuration and
select:
•
Yes to allow the field computer to automatically align sections end-to-end on the swath midpoint
and adjust the overall width to the sum of the section widths, or
•
No to manually set the section locations and keep the overall width entered previously.
Refer to the Advanced Section Setup section on page 232 for assistance with manual section
location settings.
This screen displays an overview of the section configuration at the top of the screen, the current values for
the overall boom system width and offsets, and the width and offset from the GPS antenna for each section.
For simple boom configurations, check that the system overview reflects the actual physical application
7.
equipment or implement and touch OK to save the displayed settings.
For non-standard or specialized boom or implement configurations (e.g. boom sections not aligned end-to-
end, boom sense wires not connected in left to right order, etc.), the field computer will require additional
boom configuration information. Refer to the Boom Cal or Section Width Calibration section on page 230 for
more information on adjusting section offsets for non-standard configurations, adjusting the boom sense
"Wired As" settings or customize the display characters for the Viper Pro main screen.
Manual No. 016-0171-122 Rev. I
Initial Set Up and Navigation
49