Existing Jobs; Viewing An Existing Job; Adding To An Existing Job - Raven Viper Pro Installation & Operation Manual

Chapter 5

Existing Jobs

Jobs previously created on the Viper Pro may be reopened to complete report information or to resume a field
operation. The following options are available when opening an existing job file:
•
View the existing job
•
Add to the existing job

Viewing an Existing Job

When viewing an existing job, application information may not be added. Use this feature to view job
information without editing or modifying any application data.
Press Menu, then Start Job, From File and View Only. The Select Existing Job File screen opens.
1.
Select a job from the list and touch OK. Viper opens the job.
2.
Press Menu, Close Job to close the job.
3.
Note:
If the field computer is enabled to receive web notifications via the Slingshot server, a prompt or
dialogue may be displayed after the Close Job button is selected. Refer to the Wireless File
Transfer section on page 193 for more information.

Adding to an Existing Job

Previously closed jobs may be reopened and the application or coverage map may be modified by adding to
the application. This feature is useful if a job has been closed because of a change in weather conditions, lack
of materials, etc.
Note:
When re-opening an existing job, Viper will automatically pause the application. To add to the job,
un-pause the job before starting product application to allow the Viper to modify the job
information.
The original data is used when adding to the job file. Make sure that all files created in or used by the existing
job are still available on the Viper Pro field computer and verify that the original machine configuration is the
same as when the job was initially started. These parameters include number of booms, boom widths, boom
offsets, etc.
Note:
The original swath pattern will be used to provide guidance when the existing job is restarted. Due
to shifts in satellite geometry between active job sessions, the operator should perform a swath
recalibration to update the guidance information and swath position for the actual machine
location.
Select Menu, then Start Job, From File, and Add to Job. The Select Existing Job File screen displays.
1.
Select the existing job to open from the list and touch OK. Viper loads the job information.
2.
Press Menu, and Cont. Job to add to the job.
3.
Note:
If the field computer is enabled to receive web notifications via the Slingshot server, a prompt or
dialogue may be displayed after the Cont Job button is selected. Refer to the Wireless File
Transfer section on page 193 for more information.
84 Viper Pro Installation & Operation Manual