Table of Contents
Advertisement
Setting the Fixed Contour Pattern
The fixed contour pattern allows the operator to set an irregular A-B Line pattern. To begin swath guidance with
the fixed contour pattern:
Touch the 'Set A' button to begin recording an irregular A-B line path. Viper Pro will begin plotting the
1.
vehicle position as the machine moves along the desired path.
Drive the desired path to the end of the swath.
2.
At the end of the swath, touch the 'Set B' button on the screen. Viper will connect the points plotted along
3.
the contour and display the driven path with a blue line. Guidance for subsequent swaths will be based on
the original contour and the swath number will be displayed in the upper right corner of the screen.
Note:
Curvature of the Fixed Contour guidance path should not be too aggressive. Overly aggressive
curves may produce undesirable results.
Setting the Last Pass Pattern
If Swath Guidance is enabled, the Viper Pro will automatically display the 'Guide' tab when a job is opened.
The last pass pattern provides guidance based upon the nearest covered area so the operator does not need
to set points or record a swath path. To begin Last Pass guidance, begin applying product. Once the first swath
path is completed, Viper will detect the nearest area previously covered and use the programmed overall width
to determine the next guidance path.
Note:
Last Pass Guidance is based on the nearest covered area so the booms must be on in order to
utilize this guidance pattern.
Turn Around Lock
The Last Pass pattern uses the nearest, previously applied area, or last pass, to determine the guidance for
the next swath. If headlands areas are present and the Last Pass mode is active, the Viper Pro may display a
guidance line along the headlands area instead of the next swath.
Manual No. 016-0171-122 Rev. I
Lock Enabled
Viper Pro Guidance
Turn Around
Lock
Lock Disabled
113
Advertisement
Table of Contents
Troubleshooting
