Table of Contents
Advertisement
Raven GPS Setup
To automatically configure the GPS Comm Port Setup for a Raven DGPS receiver, touch Menu, then Setup
1.
and Comm Ports. The GPS Comm Port Setup screen displays.
Select the Raven GPS preset to automatically configure the communication ports for the following
2.
receivers:
Note:
Make sure that the Raven receiver is properly connected and powered up before configuring it
with the Viper Pro system. Viper will automatically configure the GPS comm port to the following
settings:
•
Baud = 19200
•
Data Bits = 8 bits
•
Stop Bit = 1
•
Parity = None
Touch the View Data button to confirm that the Viper Pro is receiving GPS messages or touch OK to return
3.
to the Viper Pro main screen.
Note:
If the Viper Pro is unable to receive GPS messages from the Raven receiver, refer to Chapter 12,
Troubleshooting the Viper Pro System, or contact a local Raven dealer for assistance.
Manual No. 016-0171-122 Rev. I
•
•
RPR 100S
•
•
RPR 100G
•
•
Invicta 110
•
•
Invicta 115
•
Invicta 210
Advanced Settings and Features
Invicta 310
Phoenix 50
Phoenix 200
Phoenix 250
165
Advertisement
Table of Contents
Troubleshooting
