Install The Powerglide Wiring; Connect The Harness To The Boom Function Controls; Connect The Harness Cable To The Controller Cable - Raven AutoBoom Installation Manual

Install the PowerGlide Wiring

Wiring Connections
Note:
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006)
generously on both the male and female ends of the connectors. Application of the grease will
prevent corrosion to the pins and wires.

Connect the Harness to the Boom Function Controls

On the AutoBoom harness cable (P/N 115-0230-003), locate the Left Solenoid connector and connect it to
1.
Port 4A on the AutoBoom valve.
Connect the Right Solenoid connector to Port 4B on the AutoBoom valve.
2.
Machine's Up Cylinder Wiring
FIGURE 8.
Install the weatherpack boom sense adapter cables (P/N 115-0230-558) between the machine's cylinder
3.
Up coils and the connectors.
Connect the cable Up connectors on the Autoboom harness (P/N 115-0230-003) to the installed boom
4.
sense adapter cables.
Note:
The system will now disengage when Up is pressed on the machine's controller. The system must
be engaged via the AutoBoom controller or field computer screen.

Connect the Harness Cable to the Controller Cable

Route the harness cable (P/N 115-0230-003) toward the machine's cab.
1.
Connect the harness cable to the controller cable (P/N 115-0230-002).
2.
Tighten the connector cap to secure the connection.
3.
Manual No. 016-0230-066
CAUTION
Always connect the power cable as the last
step in the wiring process and verify that the
power leads are connected with the correct
polarity. Reversing power leads can cause
severe damage to the equipment.
PowerGlide
15