Convert the Sprayer's Hydraulic Valve to Open Center (If
Applicable)
By factory default, the machine's main hydraulic valve is configured as a "closed center" hydraulic system. In
order for AutoBoom to function properly and to prevent the hydraulic system from overheating, Raven
recommends converting the machine's hydraulic system to an "open center" system.
Note:
Contact your sprayer dealer to obtain the open center conversion kit.
Converted Hydraulic Valve - Closed Center to Open Center
FIGURE 1.
Install Fittings on the AutoBoom Valve
Before mounting the AutoBoom valve on the machine, install the proper fittings on the valve. This prepares the
valve for installation and simplifies the hose connection process later in the procedure. Refer to the following
table to install the fittings in the appropriate ports of the AutoBoom valve.
Fittings Installed on the AutoBoom Valve
FIGURE 2.
Manual No. 016-0230-066
PowerGlide
9