Table of Contents
Advertisement
2.
OTHER DISPLAY FEATURES
See Appendix 9 for detailed outline of each Console key and what features are
located under them.
1)
1)
1)
1)
1)
To display the set operating modes for units of measure (US, SI, TU), speed sensor
type (SP1, SP2), and valve type (C-Sd, C-FC), depress
continue holding. DATA display will toggle thru selections until key is released.
2)
2)
2)
2)
2)
To display TOTAL AREA covered, depress key labelled
To "zero out" this total at any time, enter a "0" in this key.
3)
3)
3)
3)
3)
To display TOTAL VOLUME sprayed, depress key labelled
To "zero out" this total at any time, enter a "0" in this key.
4)
4)
4)
4)
4)
To display speed in MPH [km/h], depress key labelled
5)
5)
5)
5)
5)
To display DISTANCE in feet [m] traveled, depress key labelled
To "zero out" this total at any time, enter a "0" in this key.
6)
6)
6)
To display actual application flow rate in GAL/MIN [li/min], place MASTER switch
6)
6)
in ON position and depress key labelled
To display target application flow rate, place MASTER switch to OFF and depress
key labelled
To display the volume/minute being applied, depress key labelled
seconds.
7)
7)
7)
7)
7)
To display current VALVE CAL setting, depress key labelled
VALVE CAL number will show in DATA display.
8)
8)
8)
To view any of the set calibration numbers, depress the corresponding calibration
8)
8)
keys.
.
16
for 5 seconds and
.
.
.
.
for 5 seconds.
.
for 5
Hide quick links:
Advertisement
Table of Contents
