Surface Mounting; Attaching Annunciator / Door Assembly To Backbox; Backbox Surface Mount Holes - Honeywell IFP-2100 Installation And Operation Manual

LS10143-001SK-E
4. Attach the annunciator and door assembly to backbox as shown in Figure 4-14 using the supplied screws.
Figure 4-14 Attaching Annunciator / Door Assembly to Backbox

4.5.1.2 Surface Mounting

The Model RA-100TR red trim ring and RA-2000GRAYTR gray trim ring kits are available for use when
surface mounting the RA-2000.
1. Remove the desired knock out. See Figure 4-13.
2. To properly mount the backbox, insert a single screw into the key shaped mounting hole. Do not tighten all
the way. See Figure 4-15.
Place a level on top of the backbox, with the backbox level insert the rest of the mounting screws
3. Run wires to the control panel.
key shaped
mounting hole
backbox
mounting holes
Figure 4-15 Backbox Surface Mount Holes
4-12
Control Panel Installation
.