Table of Contents
Advertisement
LS10143-001SK-E
8.2
Mapping Overview
This section of the manual is a high level overview of mapping.
Mapping is an important concept with the control panel. In general terms, mapping is assigning or linking events
to outputs that will activate when events occur. You do this by assigning input points to input zones, output points
to output groups and then linking or mapping zones and output groups.
Figure 8-1 is a brief overview of the concept of mapping. The next several pages of the manual show these
subjects in detail.
Note: Supervised notification Outputs mapped to General troubles on the NAC circuit should be made latching.
Failing to do so will cause the circuit to continually cycle into and out of trouble until silenced or restored,
if that circuit goes into trouble with an open of short condition.
Figure 8-1 Mapping Overview
8-4
Programming Overview
Advertisement
Table of Contents
Troubleshooting
