Table of Contents
Advertisement
LS10143-001SK-E
9.6.4.6 Auto-Resound (4 or 24 hours)
The system resound time period can be modified from the default value 24 hours to 4 hours. This setting adjusts
when the FACP will automatically resound events after being silenced. Set this option to 4 hours when using
SWIFT devices
9.6.5
Miscellaneous Options
Through this programming option you can do strobe synchronization during silence, and auto display event.
To edit Miscellaneous options:
1.
Enter the installer code. The panel will automatically go to the main menu.
2.
Select 7 for Panel Programming.
3.
Select 5 for System Options.
4.
Select 5 for Miscellaneous Options
9.6.5.1 Strobes Active when Silenced
When "SYNC Strobe:" is selected as Y (Yes), the strobes will continue to flash when the system is silenced and
will stop flashing when the system is reset.
Note: The "SYNC Strobe:" only functions with outputs that use a synchronized output pattern.
5.
Press the up or down arrow key to toggle this selection between Y (Yes) or N (No).
6.
Press right arrow key
9.6.5.2 Auto Display Events
When this feature is programmed Y (Yes), the highest priority event of the system in control will automatically
display on the control panel and remote annunciators after there has been no activity on any system touch pad for
two minutes.
7.
Press the up or down arrow key to toggle this selection between Y (Yes) or N (No).
8.
Press right arrow key
9.6.6
Daylight Saving Options
To edit Daylight Saving Time:
1.
Enter the installer code. The panel will automatically go to the main menu.
2.
Select 7 for Panel Programming.
3.
Select 5 for System Options.
4.
Select 6 for Daylight Saving Option.
9.6.6.1 Automatic Daylight Saving Adjustment
The control panel has an automatic DST (Daylight Saving Time) adjustment feature. If this feature is not enabled
(set to No), the Daylight Saving Time change is not made to the system clock.
To enable or disable DST adjustment continue programming:
5.
Select Y (enabled) or N (disabled) by pressing the up or down arrow key, then press ENTER.
ENTER to make your selection and move to the next programming option.
or
ENTER to make your selection and move to the next programming option.
or
9-28
Programming
Advertisement
Table of Contents
Troubleshooting
