5865-3 / 5865-4 Led Annunciator Installation; Facp Connection - Honeywell IFP-2100 Installation And Operation Manual

LS10143-001SK-E

4.12 5865-3 / 5865-4 LED Annunciator Installation

The 5865-3 and 5865-4 are LED annunciators. The 5865-4 has 30 mappable LEDs, remote fire system silence
and fire system reset key switches, and a general system trouble LED. The 5865-3 has 30 mappable LEDs only.
These are arranged as 15 pairs of red (typically used for alarm) and yellow (typically used for trouble) LEDs.
Installation of the 5865-3 and 5865-4 is identical. The key switches and the trouble LED follow the behavior of
other system annunciators and do not require any installation steps. The following sub-sections describe how to
install the 5865-3 and 5865-4 hardware. Refer to Section 9 for programming information.
Note: This manual uses "5865" when referring to aspects of the 5865-3 and 5865-4 that are common to both
models.
Numbers indicate
point numbers for
5865. (They do
not appear on board
assembly.)
1 2
3 4
5 6
7
8
10
9
4.12.1

FACP Connection

The 5865 connects to the panel via the SBUS. Make connections as shown in Figure 4-42. After the 5865 is
connected to the panel, it must be added to the system. This programming step is described in Section 9.2.2.
supervised
power limited
Plexiglass plate mounted to LED board at factory.
21 22
11 12
SILENCE
14 24
23
13
15 16 25 26
TROUBLE
27 28
18
17
19 20 29 30
5865-4 Board Assembly
Figure 4-41 5865-3 and 5865-4 Assembly (front view)
Figure 4-42 5865 Connection to the FACP
Do not remove.
5865-4 switches
follow main FACP;
no installation
or programming
required.
RESET
4-30
Control Panel Installation
5865-3 Board Assembly