Compatible Products; Terms Used In This Manual - Honeywell IFP-2100 Installation And Operation Manual

Model IFP-2100/ECS Installation Manual
1.1.5

Terms Used in this Manual

The following terminology is used with the above mentioned control panels:
Term
SLC
Module
Input Point
Input Zone
Output Point
(or "Output Circuit")
Group (or "Output Group" or
OPG)
Mapping
Networking
Network System
ECS
SWIFT
1.2

Compatible Products

Table 1-1 lists the products available for use with the IFP-2100/ECS.
Type of Device
IDP Addressable See Section 7.1 for a list of compatible devices
SLC Devices
SK Addressable See Section 7.2 for a list of compatible devices
SLC Devices
SD Addressable See Section 7.3 for a list of compatible devices
SLC Devices
SWIFT Wireless See Section 7.4 for a list of compatible devices
SLC Devices
5824 Serial/Parallel Printer
Interface Module
5815XL (Rev H or above)
Other Modules
SLC Expander
Signaling line circuit
The term module is used for all hardware devices except for SLC addressable devices and
notification appliances. This includes the IFP-2100/ECS/RFP-2100 panels itself and the built-in
power supply. It also refers to any (optional) 5815XL or 6815 SLC expansion modules.
An addressable sensing device, such as a smoke, heat detector or a contact monitor device
A protected area made up of input points
A notification point or circuit for notification appliances. Relay circuits and auxiliary power
circuits are also considered output points
A group of output points. Operating characteristics are common to all output points in a group
Mapping is the process of specifying which outputs are activated when certain events occur in
the system. Section 8.2 explains mapping in detail
Up to 32 panels can be networked.
Consist of any combination of 32 panels of these model numbers: IFP-75, IFP-300, IFP-
300ECS, IFP-2100, IFP-2100ECS, RFP-2100, IFP-2000, or IFP-2000ECS
Emergency Communication System
Smart Wireless Integrated Fire Technology
Table 1-1: IFP-2100/ECS Compatible Products
Model
Allows a printer to be attached for the system for on-site logging. Four
maximum per system.
Each 5815XL allows up to 127 SD devices to be added to the system. The
number of 5815XLs that can be added to the system is limited only by the
maximum number of SBUS devices. However the maximum SD point
count is limited to 2032 per panel. 5815XL will only support SD protocol
devices
Description
Description
1-3
LS10143-001SK-E