Table of Contents
Advertisement
LS10143-001SK-E
green Select Key LED will indicate that a message is currently programmed in the corresponding slot. When
there is no message recorded (or the message is erased), the associated green Select Key LED will be off. While
recording a particular message, the associated red Select Key LED will turn on until recording is completed. The
Select Key 1-15 will be used to playback a recorded message or to select the message slot to record to or erase.
When in the Local Record mode, the ECS-VCM or ECS-NVCM LEDs will function as follows:
LED
Select Key 1-15 Green LED
Select Key 1-15 Red LED
Select Key 1-15 Green/Red LED
Select Key 1-15 Red LED
11.8.1
Recording Messages 1-15 Using Aux Audio Input
Recording messages from the Aux Audio Input enables you to load customized, pre-recorded messages into an
ECS message location.
Follow these steps to record a user message using Aux Audio Input:
Note: Refer to section 9 for detailed programming information.
1.
Wire a speaker cable with 1/8" mini plug to the Aux AUDIO GND and IN terminals. Refer to Figure 11-5.
2.
Plug the mini plug into the Line Out/Headphone jack on a PC or laptop. See Figure 11-5.
3.
Enter programming mode at main control panel.
4.
Select 8 for Voice Options.
5.
Select 1 for VCM Maintenance.
6.
Select 2 Local Recording.
Table 11-1: LED Functions During Programming
LED State
On
On
Off/Off
Flashing
Figure 11-5 Aux Audio Connection for Recording
Emergency Communication System Operation
Meaning
Message is currently programmed in this slot
Message recording is in progress
Message slot is empty
Message is being played back or message is selected for
recording
11-12
Plug in here
Advertisement
Table of Contents
Troubleshooting
