List Of Swift Wireless Slc Devices; Maximum Number Of Slc Devices; Wiring Requirements For Slc Devices - Honeywell IFP-2100 Installation And Operation Manual

LS10143-001SK-E
7.4

List of SWIFT Wireless SLC Devices

Table 7-4 list available SWIFT Wireless SLC devices can be used with the control panel. See the appropriate
section number in this manual or the device installation instructions (packaged with the device) for more
information.
SWIFT
Model Number
WIDP-WGI Wireless Gateway
WIDP-PHOTO Wireless Photoelectric Smoke Detector w/ 4" base
WIDP-ACCLIMATE Wireless Multi criteria photoelectric smoke detector with thermal (135°F) w/ 4" base
WIDP-HEAT-ROR Wireless Heat Rate of Rise Detector 135° fixed w/4" base
WIDP-HEAT Wireless Heat, 135° fixed Heat Detector w/4" base
WIDP-MONITOR Wireless Addressable Monitor module
WIDP-RELAY Wireless Addressable Relay module
B210W 6" wireless base
WSK-WGI Wireless Gateway
WSK-PHOTO Wireless photo with 4" base
WSK-PHOTO-T Wireless Multi criteria photoelectric smoke detector with thermal (135°F) w/ 4" base
WSK-HEAT-ROR Wireless heat, ROR/ 135° fixed with 4" base
WSK-HEAT Wireless Heat, 135° fixed with 4" base
WSK-MONITOR Wireless monitor module
WSK-RELAY Wireless relay module
B210W 6" wireless base
7.5

Maximum Number of SLC Devices

The IFP-2100/ECS supports IDP, SK,SD, or Wireless SLC devices. The maximum number of SLC devices per
panel is 2100 for IDP or SK devices, or 2032 if using SD devices. The number of SLC expanders is limited only
by the SBUS bandwidth, point count, and 1A SBUS current limit. Device support is as follows:
• IDP or SK Devices - The IFP-2100/ECS supports a total of 2100 IDP or SK points. The SLC points can be
all sensors or all modules or any combination of modules and sensors.
or
• SD Devices - The IFP-2100/ECS system can support a total of 2032 SD devices, in any combination. SD
devices are only supported on the 5815XL.
or
• IDP SWIFT Wireless Devices–A SWIFT Gateway system supports up to 50 devices: 1 SWIFT Gateway and
up to 49 (in any combination) wireless detectors and monitor modules. Multiple Gateways can be used. See
the SWIFT manual P/N LS10036-000FH-E for more information.
7.6

Wiring Requirements for SLC Devices

The following information applies to SLC devices. Refer to the section that describes the type of device you are
installing for details.
IDP, SK, SD and SWIFT™ SLC Device Installation
Table 7-4 SWIFT Wireless Devices
Model Name/Description
7-4
Install
Sheet PN
LS10036-000FH-E
LS10036-000SK-E