Installing An Ac Or Dc Power Tray; Prerequisites - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Installing an AC or DC Power Tray

Figure 10: DC Power Tray — Rear View (Clear Plastic Safety Cover Removed)
Installing an AC or DC Power Tray
This section describes how to install an AC or DC power tray in the Cisco NCS 6000 FCC.
Note For information about removing a power tray, see the
section.

Prerequisites

Before you install an AC or DC power tray, do the following:
• Remove the top grilles from both the front and rear sides of the FCC, if installed.
• Ensure the power tray you are about to install is empty. Do not install a power tray into the FCC with
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
18
the PMs installed in the power tray.
Installing the Power Enclosure, Power Trays, and Exterior Cosmetics
Replacing an AC or DC Power Tray, on page 99