Table of Contents
Advertisement
Removing an AC or DC Power Module
Removing an AC or DC Power Module
This section describes how to remove a power module from a power tray.
Prerequisites
Before performing this task, you must first remove the top grille on the front side of the FCC, if installed See
the
Installing the Front Exterior Cosmetics, on page
It is not necessary to turn off the switch on the power tray to remove individual power modules. Power
Note
modules support OIR, so they can be removed and replaced with the power on and the system operating.
Required Tools and Equipment
• ESD-preventive wrist strap
• 6-inch, Number-1 Phillips screwdriver
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
102
Removing and Replacing Chassis Components
22.
Advertisement
Table of Contents
Need help?
Do you have a question about the Network Convergence System 6000 Fabric Card Chassis and is the answer not in the manual?
Questions and answers