Installing an AC or DC Power Module
Ensure that the ground cable is installed on the FCC before you install the power modules and input power
Note
cables. See the
Installing an AC or DC Power Module
This section describes how to install an AC or DC power module (PM) into the power trays in the Cisco NCS
6000 FCC. Although there are differences between the AC and DC PMs, they are installed by using the same
procedures.
An AC-powered FCC supports up to 12 AC PMs (three per power tray). A DC-powered FCC supports
Note
up to 16 DC PM (four per power tray).
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
12
Installing the Fabric Card Chassis Ground Cable, on page
Installing the Power Components
1.