Installing Dc Power Tray; Installing An Ac Or Dc Power Tray - Cisco NCS 4000 Series Hardware Installation

Installing DC Power Tray

1
3
Step 4 Use the torque wrench to tighten the screws to a torque of 22-25 in-lb
Step 5
Connect the other end of the ground cable to a grounding point at your site, according to site requirements.
Installing DC Power Tray
The following procedure describes how to install a DC power tray in the chassis.
Required Tools and Equipment
• 6-inch, number-1 Phillips screwdriver
• Cisco NCS 4000 FCC power trays (NCS4K-DC-PEM)
Steps
Follow these steps to install a DC power tray into the chassis:
Hardware Installation Guide for Cisco NCS 4000 Series
32
Screws
Grounding point in front of the chassis
Installing Power Components
2 Grounding lug with cable
Grounding point on left side of the chassis