Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual page 160

Cabling the Control Plane for a 2+1 Multi-Chassis system
The RPs can be attached to any port on the SC-SW card.
Note
Figure 74: Control Plane Cabling for a 2+1 Multi-Chassis System
Table 22: RP Cards to SC-SW Card Connections (2+1 Configuration)
LCC0
LCC1
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
146
From RP Port
RP0, EXP0
RP1, EXP0
RP0, EXP1
RP1, EXP1
RP0, EXP0
RP1, EXP0
RP0, EXP1
RP1, EXP1
Cabling a Multi-Chassis Configuration
To SC-SW Card
FCC0, SC0 any switch port
FCC0, SC0 any switch port
FCC0, SC1 any switch port
FCC0, SC1 any switch port
FCC0, SC0 any switch port
FCC0, SC0 any switch port
FCC0, SC1 any switch port
FCC0, SC1 any switch port