Installing An S2 Fabric Card Impedance Carrier; Prerequisites; Required Tools And Equipment - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Installing the Shelf Controller Cards and Fabric Cards
The SC0 and SC1 slots on the front of the FCC do not have impedance carriers as these slots on the front
Note
of the FCC must be populated with either two SC or SC-SW cards at all times.
Figure 42: S2 FC Impedance Carrier

Installing an S2 Fabric Card Impedance Carrier

This section describes how to install an S2 fabric card impedance carrier in the Cisco NCS 6000 FCC.

Prerequisites

Before performing this task, open the cosmetic doors, if installed, and ensure that the slot in which you are
about to install the impedance carrier is empty.

Required Tools and Equipment

• Number-2 Phillips screwdriver or Number-2 common (flat-head) screwdriver
• Fabric card impedance carrier (Cisco PID NCS-F-FC-BLANK)
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
Installing an S2 Fabric Card Impedance Carrier
67