Installing The Rear Exterior Cosmetics; Prerequisites; Required Tools And Equipment; Steps - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Table of Contents

Installing the Rear Exterior Cosmetics

This section describes how to install the rear side exterior cosmetics on the Cisco NCS 6000 FCC. We

recommend that you install the exterior cosmetic components in the order outlined in this section.

Installing the Power Enclosure , on page 14

Installing the Front Exterior Cosmetics, on page 22

• 8-inch, Number-1 Phillips screwdriver (magnetic head preferable)

• Two vertical cable troughs (left and right are interchangeable)

• Three door hinges

• Three door latches

• Four trough retention brackets

• Exhaust plenum bracket

• Rear door

• Door grounding cable

• Rear exhaust air deflector

To install the rear exterior cosmetics, follow these steps:

Step 1

Remove the upper and lower horizontal cable management brackets (preinstalled on the FCC) by loosening and removing

the eight pan-head screws (four per bracket). One bracket is located above the upper card cage and the other bracket is

below the lower card cage.

Step 2

Attach the left and right vertical cable troughs to the rear of the FCC. The two vertical cable troughs are inverted from

each other. Each trough is marked REAR to ensure that you install the trough on the correct side of the FCC.

Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide

Installing the Power Enclosure, Power Trays, and Exterior Cosmetics

Table of Contents